The controls of the SYMA X5C RC Quadcopter are simple enough to be handled by first-time flyers, with a few caveats. This is pretty standard for a lot of remote-controlled aerial devices, but more modern and high-end drones feature the ability to maintain a given elevation at a constant. The main shortcoming is the lack of a true hover mode, but the throttle is on the left stick does at least stay in place to prevent accidental descent. We didn’t have any difficulty getting the X5C off the ground and maneuvering around in the air-the controls were responsive and the drone didn’t have any unexpected disposition in a given direction. If you prefer, you may switch to Mode 2, which flips the yaw and roll controls. This is the default layout, which SYMA calls Mode 1. The SYMA X5C RC Quadcopter features a fairly standard control scheme for flight, with the left stick handling throttle/hover and rotation (yaw), and the left stick handling forward, backward, and sideways motion (pitch and roll). Note that there is a pre-flight routine that must be performed to sync the transmitter and enter its pre-fly state.Ĭontrols: Straightforward flight control, complicated everything else
Syma drone weight manual#
With the battery installed back in the frame and a microSD card for any photos you wish to take, simply follow the instructions outlined in the manual to operate the remote control and fly the drone. The blades come already attached in the box, unlike many drones, but the blade guards still need to be installed using the included screws.Īfter these steps, you should be ready for flight. We found the setup process to be fairly simple and straightforward, requiring most of the usual steps we’ve become accustomed to when it comes to drone setup. After approximately 100 minutes, the battery should be fully charged and ready for flight. This battery is then connected to the included USB charging cable and can be simply charged from any USB port. When you first unpack the contents of the box, locate the battery cover on the underside of the drone and remove the battery, making sure to pull the battery wire from the power port before removing it from its casing. Not included are the four AA batteries necessary to operate the remote control so make sure to purchase these in advance. In the box, you’ll find the quadcopter, remote control, four main blades, four screws, a screwdriver, USB charging cable, battery, and instruction manual. It also features one of the worst control schemes we’ve seen, which we will explore more in a later section. The construction of the remote control is very flimsy, featuring a number of functionless vestigial buttons that are unnecessarily distracting. This is perhaps the single most prominent part of the X5C that screams “budget”.
You won’t get any award-winning photos or videos out of the tiny sensor on this super cheap camera.Īnd finally, the remote control. The SYMA X5C RC Quadcopter comes equipped with a camera, although it’s certainly an afterthought. As long as you observe some basic precautions during flight, you should be able to fly this drone for a long time.
0 kommentar(er)
